1967 Shelby Cobra 427 Replica in LeMans Blue — Custom-Built by John's Custom Fabrications
About this vehicle
John's Custom Fabrications has a real reputation in Cobra replica circles, and this car reflects why. Rather than sourcing a kit, builder John Paulis fabricated it to original 427 dimensions — a distinction that shows up immediately in how the proportions sit. It was commissioned for a personal friend of his, passed to its current owner in 2015, and now shows 5,270 miles.

LeMans Blue over Wimbledon White stripes. That's the combination. The original cars wore it best, and it works here just as well. Aluminum side louver vents line the flanks, polished side-exit exhaust pipes cut a purposeful profile, and Shelby Cobra 427 badging on the hood, trunk, and front fenders keeps everything period-correct at a glance. Up front, ultra-bright LED headlights sit alongside classic "Beehive" turn-signal lenses — a small touch that reads right. The rolling stock is staggered Halibrand-style ET III five-lug wheels, 15"x8" at the front and 15"x10" at the rear, with pin-drive spinner covers and BFGoodrich rubber all around: P235/60R15 up front, P295/50R15 out back.

Tight cockpit. Black leather on the low-back bucket seats, door panels with expandable map pockets, and the dash, which gets a locking glove compartment. A Momo wood-rimmed steering wheel anchors the driver's position, and the Stewart Warner gauge package covers everything you'd want: an 8,000-rpm tachometer, a 160-mph speedometer, plus readouts for oil pressure, oil temperature, coolant temperature, voltage, and fuel level. Both seats are equipped with Ultra Shield 4-point harnesses, and safety hardware extends to a padded chrome-moly roll bar and a fire extinguisher, with two kill switches as well. The driver's footbox and pedals have been extended forward to accommodate drivers up to 6'3".

Under the hood the 390ci FE-series V8 has been bored and stroked out to 431ci. The seller puts output at 475 horsepower and 500 lb-ft of torque. Induction runs through a Holley 750-cfm four-barrel carb seated inside a polished Shelby Cobra 427 "Turkey Pan" cold-air box, all sitting atop a polished Ford 427 FE aluminum intake. Polished Cobra-branded valve covers and polished headers feed the open side pipes. Drive passes through a Tremec TKO 600 5-speed manual with a custom shifter, then on into a limited-slip Ford 9-inch differential geared at 3.50:1. Worth knowing: the updated engine and driveline have fewer than 500 miles on them, and a recent oil and fluid change has already been done.

Chassis hardware includes a custom 4-link rear suspension with adjustable Heim joints, Wilwood four-piston disc brakes with drilled and slotted rotors at all four corners, an aluminum radiator, a billet aluminum reservoir, and braided stainless-steel lines front to rear. The whole underside reads clean and considered.
The sale includes a clean California title, two keys, and a car cover.

