BMW 528I Coolant Parts
Showing 20 out of 138 part(s) found in our catalog.
Brand
Keyword
Category
Select category below to view parts.
Mon-Fri 8-4 MST/PST (Arizona Time)
The average cost of a BMW 528I coolant is between $0.69 and $44.99.
The coolant recommended for a BMW 528i can vary depending on the year and model of the vehicle. However, the most common type of coolant used in BMW 528i models is ethylene glycol-based coolant. This type of coolant is typically a mix of ethylene glycol and water, along with various additives that help to prevent corrosion, foaming, and scale formation in the engine's cooling system.
BMW recommends using a specific type of ethylene glycol-based coolant that meets the BMW LL-01 standard. This standard ensures that the coolant provides the necessary protection for the engine's aluminum components and is compatible with the engine's seals and gaskets.
How to Add Coolant to Your BMW 528i
To add coolant to your BMW 528i, you will need to locate the coolant reservoir, which is typically located near the front of the engine compartment on the passenger side of the vehicle. Here are the general steps to add coolant to your BMW 528i:
- Park your BMW 528i on a level surface and turn off the engine. Allow the engine to cool down for at least 30 minutes before attempting to add coolant.
- Open the hood and locate the coolant reservoir. It is typically a translucent plastic container with a black cap.
- Remove the coolant reservoir cap by turning it counterclockwise. Be careful not to remove the cap while the engine is still hot, as this can cause the hot coolant to spew out and burn you.
- Check the current level of the coolant in the reservoir. The coolant level should be between the minimum and maximum marks on the side of the reservoir. If the level is low, you will need to add more coolant.
- Add the coolant. Slowly pour the coolant into the reservoir until the level reaches the maximum mark. Be sure to use the recommended type of coolant for your BMW 528i, and do not mix different types of coolant.
- Replace the cap on the coolant reservoir and tighten it by turning it clockwise.
- Start the engine and let it run for a few minutes. Check the coolant level again to ensure that it is at the proper level.
If you are unsure about how to add coolant to your BMW 528i, it's always a good idea to consult your owner's manual or take your vehicle to a trusted mechanic.
AutohausAZ carries BMW 528i coolant at a fraction of the cost you'd pay at the dealership. Save time and money by having your 528i coolant shipped directly to your doorstep.
